British Columbia Cost Guides · Kamloops
How Much Does Sump Pump Installation Cost in Kamloops, BC?
Typical cost in Kamloops
$1,350
$400 low · $2,850 high
All-in installed price: pump, basin and discharge where the job includes them, plus labour · Updated July 2026
Installing a sump pump in Kamloops costs $400 to $2,850 installed, and most homeowners pay around $1,350 for a standard submersible pump in a residential basin. Two versions of this job share one name. Dropping a new pump into a basin that already exists is an hour's work and a few hundred dollars. Cutting a new pit into a basement floor, setting a basin, and running a discharge line out through the wall is a different scope with a different number. The figures below keep the two apart, because contractors quoting them rarely do.
Kamloops gets less rain in a year than the coast gets in a season, so a great many houses here have never had a sump and have never wanted one. Where pits do turn up it is on the low ground near the Thompson rivers, where freshet raises the table for a few weeks each spring, or below the silt bluffs where irrigation and lawn water work their way down. In those houses a swap is $400 to $1,000 and a first pit $1,500 to $3,000. Interior labour runs a few points under the provincial average.
Looking For a Contractor?
Want sump pump installation done at a fair price like the ones on this page? Leave your contacts — we'll pass them to local plumbing and drainage contractors in Kamloops, and they'll get back to you with quotes.
Get quotesFree · No obligation
By the PlumbingCosts.ca team — we track published contractor rates, supplier pricing, and permit fees across Canada because you deserve to know a fair price before anyone's in your basement.
Price by Job Type in Kamloops
| Job | Low | Average | High |
|---|---|---|---|
| Pump swapped into an existing pit | $400 | $550 | $950 |
| New pump, basin and discharge at an existing sump opening | $600 | $1,150 | $1,650 |
| New sump pit cut and dug into the floor | $1,450 | $2,100 | $2,850 |
| Pump unit alone, at Canadian retail | $150 | $350 | $550 |
What's in the Price — and What Isn't
In the price
- The pump, sized to the lift and the water volume rather than to the shelf price
- Basin and lid where the job includes them, seated on gravel so silt doesn't wreck the impeller
- Discharge piping with a check valve, so what you pump out doesn't run back in
- Connection to the existing perimeter drain or footing tile where one comes in
- Testing under a real load, not a bucket of water down the side
Costs extra
- A dedicated circuit if the basement doesn't already have one — that's an electrician
- Battery or water-powered backup systems
- Breaking and patching a concrete floor beyond the pit itself
- Trenching a long buried discharge run across the yard
- Perimeter drain work, if the reason the pit fills is that the footing drain has silted up
Ask what the quote assumes about the pit. "Sump pump installed, $1,600" reads the same whether the crew is dropping a pump into an existing basin or cutting a hole in your floor, and those jobs are a thousand dollars apart. Get the pump's horsepower, its rated flow at your actual lift height, and whether the basin is included.
Calculate Your Estimate
What Moves the Price
- Whether there's already a pit
- The whole job in one question. A Vancouver-area company publishes replacement at $400 to $540 and a new pump installation averaging $659 to $1,754. A pit that has to be broken through a concrete slab and dug out adds hours of labour and a load of spoil to haul away.
- The pump itself
- Smaller than most people expect. An entry-level 1/3 HP submersible sits at $138 on the shelf at Home Depot Canada, and BC contractors put the unit at $200 to $600 in their own quotes. On a $1,500 install the pump is a fraction of the bill; the labour and the basin are the rest.
- Where the water goes
- Discharge has to leave the building and get far enough away not to come straight back. A short run through a rim joist is routine. A long buried run to a storm connection or a splash pad at the property line is extra pipe, extra trenching, and extra time.
- Head height and flow
- How high the pump has to lift and how much water it faces decides the pump, not the salesperson. A hillside North Shore crawlspace with a two-metre lift needs more than the 1/3 HP unit that suits a flat Richmond basement.
- Electrical
- A sump pump wants its own dedicated circuit with a properly rated receptacle, and plenty of older BC basements don't have one within reach. Getting an electrician in is a separate trade and a separate line on the quote.
- Backup power
- The pump matters most during the winter storm that takes the power out. Battery and water-powered backups both exist and both add cost, but no BC contractor we could verify publishes a price for them — treat any figure you're quoted as worth a second opinion.
Where a typical $1,350 job goes:
- Materials
- 38% · ~$513
- Labour
- 58% · ~$783
- Permit & disposal
- 4% · ~$54
How the Job Actually Goes
-
Working out what the pit sees
Before anything gets priced, the contractor should establish where the water comes from, how high it has to be lifted, and whether the perimeter drain is feeding the pit properly. A pump is a symptom-management device and it needs to be sized to the symptom.
Included in the quote, or a $99 call-out at shops that charge one
-
The pit
An existing basin gets cleaned out and inspected. A new one means cutting the slab, digging out to depth, setting the basin on gravel, and getting the concrete broken up and away.
The difference between a $600 job and a $2,000 one
-
Setting the pump
The pump sits on a solid base rather than the pit floor so it isn't drawing silt, and the float gets set with enough travel that it isn't short-cycling every ninety seconds.
Pump $140–600 at retail, less at contractor pricing
-
Discharge and check valve
Pipe runs from the pump up and out through the wall, with a check valve above the pump so the column of water in the pipe doesn't drop back into the pit each cycle. The outside end has to discharge far enough from the foundation to be worth the trouble.
Part of the installed price
-
Power and testing
The pump wants a dedicated receptacle within reach and no extension cord. Then the pit gets filled and the cycle watched from start to shut-off, twice.
Included; a new circuit is an electrician's line item
Do It Yourself or Hire a Pro?
Doing it yourself
- A like-for-like swap into an existing basin is genuinely achievable: unplug, unclip the discharge, lift the old pump, set the new one, check the float
- The material gap is real. A 1/3 HP submersible is $138 at Home Depot Canada against a $400 to $540 published replacement price, so you're buying back a few hundred dollars of labour
- Nothing about a swap is permitted work, so there's no paperwork you're skipping
- Sizing by price rather than by lift height is the classic mistake. A pump that can't push water up a two-metre head runs constantly and dies early
- Skipping or reversing the check valve sends the discharge straight back into the pit, and the pump then cycles until it burns out
- Cutting a new pit is not a DIY job — it's slab work, spoil removal, and a hole next to a load path
- A pump that quits during a January storm costs many times whatever the labour was worth, and water damage claims tend to ask who did the work
Hiring a licensed pro
- Pump chosen against measured head height and the water the pit actually sees
- The pit gets set on proper gravel with a sealed lid, which is what keeps silt out of the impeller
- Check valve, discharge routing, and the tie-in to the footing drain all handled as one system
- Someone who will tell you the real answer when the pit is filling because the perimeter drain has failed
- A straightforward swap costs several times the price of the pump on the shelf
- New pit work is priced like the small excavation it is, and it takes most of a day
Our take: Swap your own pump if the basin is already there, the discharge is already run, and you can match the horsepower and the lift. Everything else — a first pit, a new discharge route, or a basement that has never had a sump and now needs one — is a contractor job, and the deciding factor is that the pump only matters on the one night a year it runs unattended.
Signs It's Time to Replace
- Water rising in the pit and the pump either not starting or running without emptying it
- A pump that cycles every minute or two, which usually means a stuck float or a failed check valve
- Rust, grinding, or a hum with no flow — all end-of-life noises on a submersible
- The pump is past ten years old and lives in a house you plan to leave for a week in winter
- A crawlspace or basement on a high water table, a hillside seep, or the low corner of a Fraser Valley lot
- No pump at all in a basement that has taken water twice, where the fix is a first install rather than a replacement
How to Keep the Cost Down
- Price the swap and the new-pit job as separate questions. A replacement in an existing basin is published at $400 to $540 in BC, and paying new-install rates for it is the most common overcharge in this category
- Buy on horsepower and rated flow at your lift height, not on brand. The published spread between contractors is far wider than the spread between comparable pumps
- If a new pit is being dug, get the perimeter drain assessed in the same visit. A pit that fills because the footing drain has silted up is treating the wrong end of the problem
- Bundle it with drain tile work if that's happening anyway — BC contractors quote $1,500 to $3,500 for a sump added to a drain tile installation, which is less than a standalone job plus a second mobilization
- Ask whether the call-out fee comes off the work. One West Vancouver shop publishes a $99 visit fee for looking at a sump, and plenty of shops credit it against the job
Kamloops Notes: Permits, Homes, Rates
Gas permits go through Technical Safety BC ($116 on a contractor permit for a 2026 swap); the City of Kamloops charges a $50 minimum plumbing permit.
Basements are standard across Brocklehurst, Sahali and Westsyde, and most stay dry most of the time, which is precisely why a pump in one can go years without being tested. Houses below the bluffs deal with water that has travelled through loose silt and arrives carrying it. Silt is what wears an impeller down, so how the pump is seated matters more here than the badge on it.
Interior rates run below the Coast, a few points under the BC average.
Questions to Ask Before You Hire
- Does this price include a basin, or is it a pump swap into what's already there?
- What horsepower, and what will it move at my actual lift height?
- Where does the discharge exit, how far from the foundation does it end, and is there a check valve?
- Is there a dedicated circuit for it, and if not, who brings the electrician?
- If you're cutting a new pit, who removes the concrete and what does the floor look like afterward?
- What's the warranty on the pump and on your labour, and are they the same length?
While the Plumber Is There
Call-out time is a big share of any bill — if one of these applies to your home, pricing it in the same visit usually beats a separate appointment.
In most BC houses the footing drain is what feeds the sump. A new pump on a silted-up perimeter drain is a fast pump with nothing to pump, and both should be looked at together.
The sump and the tank usually share a mechanical room. When a tank lets go, the sump is what decides whether you lose a floor, so it's worth knowing the age of both.
If the basement floor drain backs up at the same time the pit fills, you have two separate problems and one visit. Worth pricing the clearing while someone is already down there.
Common Questions
Sump Pump Installation Costs Across British Columbia
| City | Typical range | Average |
|---|---|---|
| Abbotsford | $400–$2,950 | $1,350 |
| Burnaby | $450–$3,250 | $1,500 |
| Chilliwack | $400–$2,900 | $1,350 |
| Coquitlam | $400–$3,150 | $1,450 |
| Delta | $400–$3,100 | $1,450 |
| Kamloops (this page) | $400–$2,850 | $1,350 |
| Kelowna | $400–$3,000 | $1,400 |
| Langley | $400–$3,050 | $1,450 |
| Maple Ridge | $400–$3,050 | $1,450 |
| Nanaimo | $400–$2,900 | $1,350 |
| New Westminster | $400–$3,200 | $1,500 |
| North Vancouver | $450–$3,350 | $1,550 |
| Port Coquitlam | $400–$3,100 | $1,450 |
| Port Moody | $400–$3,150 | $1,450 |
| Prince George | $400–$2,800 | $1,300 |
| Richmond | $450–$3,250 | $1,500 |
| Saanich | $400–$3,150 | $1,450 |
| Surrey | $400–$3,150 | $1,450 |
| Vancouver | $450–$3,350 | $1,550 |
| Victoria | $400–$3,200 | $1,500 |
| West Vancouver | $450–$3,400 | $1,600 |